In addition to connected USB drives, it might try to boot from optical first, it could have additional controllers that are going through their own self tests. I also updated the bios from version F3 to version F7 the latest versionbut still no improvement.ĭoes this means that the BIOS or the motherboard is faulty? Faisal McMissile DamieyaApr 28, Do you have any USB devices connected? Depending on the devices plugged in, the options enabled, etc. I tried remove the hard disk, CMOS battery, ram etc. The photo of the logo is shown below: On the second week onwards however, I noticed that the Gigabyte start-up logo is displayed for 35 seconds before Windows 10 is loaded. Every time I switched on the system, the Gigabyte start-up logo was displayed within 5 seconds before the Windows 10 is loaded. What can I expect to do if I was to claim RMA warranty? I have custom cooler on CPU installed.Custom Splash Screens Logos for Intel® Desktop Boards Is it possible that corrupted Backup BIOS was flashed in the process? Are there any other tips how to get to Backup BIOS? I haven't tried those suggesting to short-circuit pins yet and I want to avoid that. I have searched for methods on how to boot up in Backup BIOS but none of them resulted in anything else than those beeps and bootloops. There are 3 beeps a pause and another 3 beeps.
then without any prompting it said Rebooting in 5 seconds. I selected update and during the process again display driver failed for reasons unknown but the flashing continued to the end. Maybe if Gigabyte bothered to explicitly note what are the requirements for the picture loaded or prevented to load one which does not meet requirements this would me much less painful and time consuming.Īt one of the failed attempts where display driver failed I had to log off and log in again just to see unexpected prompt from AppCenter if I wish to update firmware. I have tried several re-flashings of the boot image but it always came messed-up. Luckily logging of the Windows session and logging in back returns everything back to normal and you can repeat the process again hoping that this time it succeeds.
RANDOMLY this process of flashing boot image causes the display driver to fail PC goes into looped bursts of lags and sound disruptions and the flashing process fails. So I repeated the process trying different colors, different resolutions etc. Everything worked out well except the Booting image was quarterly all messed-up in colors. F20 and included face-wizard picture of mine which was a 256-color png image with resolution 1024x768. I have flashed my BIOS to the latest rev. Such sensitive task as flashing BIOS is a total failure here. First, let me express how terrible GIGABYTE BIOS flashing utilities and face-wizard are.
0 kommentar(er)
